DETERMINATION OF SERUM PROTEINS BY MEANS OF THE BIURET REACTION

Abstract

In the course of an investigation of the biochemical changes following experimental liver injury we felt the need of a simple, rapid, and accurate method for determining the protein fractions in small amounts of serum. Among the simpler procedures known, the biuret reaction seemed to offer the most encouraging possibilities. Variations and improvements in the application of the biuret reaction to clinical chemistry can be traced in the works of Autenrieth (l), Hiller (2), Fine (3), Kingsley (4), and Robinson and Hogden (5). Kingsley (6) simplified the technique by adding serum directly to a “one piece” reagent. Efforts have been made to increase the stability of such biuret reagents with ethylene glycol (7), tartrate (8), and citrate (9)) We began our investigation with Kingsley’s (6) method and report briefly on the two main difficulties encountered in its use. The first is that the total protein (TP) reagent and, to a lesser extent, the albumin (ALB) reagent are not sufficiently stable. The length of time they remain so depends upon the technique of their preparation. One consequence of this variable stability is a difficulty in duplicating calibration curves with different lots of reagent. Errors may arise when results with a new reagent are read from an old calibration curve. Serious errors occur if a reagent is used after the separation of any black deposit gives evidence of deterioration. A second difficulty has been that total protein estimations made with the TP reagent and read, as prescribed, from calibration curves prepared with the ALB reagent have tended to be too low. Recorded in Table I are the results of a number of analyses in which Kingsley’s biuret procedure has been compared with the Kjeldahl method2 on both normal and ab-

Keywords

Affiliated Institutions

• University of Toronto CA

Related Publications